HiPurVR6 0 Posted January 11, 2008 Report Share Posted January 11, 2008 Hi all,I'm sure it is possible to fit the motors, switches and wiring required but has anyone done this, is it difficult and was it expensive?Also is any of the loom already fitted to a late (97) Vr?Hope you can helpPhil Link to post Share on other sites
manzi 0 Posted January 12, 2008 Report Share Posted January 12, 2008 i'm currently doin this. bit of a long task tho as i'm just takin ages about doin it.motors fit fine, theres like a small plug you unscrew and just replace with the motor. the loom however (i think) will require taking the front bumper off, i've not really got round to it yet. And the sockets behind the dash are already there.what you'll need is the loom to the lights, indicators, fogs and levelers, not the whole thing, the light switch unit with leveler control. thats it i think.i bought my levelers with oe fogs. the bag of crap i bought was partly broken, one of the levelers had been ripped off so that was glued in place and i've not fitted the fogs as they were also partly broken. paid £50. kinda pricy and i get the feeling i paid too much.my vr is also a 97 plate, so until i pull me finger out i will then know whether there are any probs.email this guy: g6016v@hotmail.co.uk i bought the stuff off him, he apparently breaks mk3 golfs. Link to post Share on other sites
HiPurVR6 0 Posted January 16, 2008 Author Report Share Posted January 16, 2008 Cheers for the reply, looks like it's something I'll be trying in a month or so!All the best with the work and let me know how it goes. Link to post Share on other sites
manzi 0 Posted January 21, 2008 Report Share Posted January 21, 2008 just to be nosy. what are you installing them for?mine are for HID's if i haven't mentioned it. Link to post Share on other sites
vr6madmike 0 Posted January 21, 2008 Report Share Posted January 21, 2008 yeah so are his! Link to post Share on other sites
HiPurVR6 0 Posted January 23, 2008 Author Report Share Posted January 23, 2008 Thanks Mike!I'm looking into getting some HID's fitted as well and thought that having the adjusters fitted would make life a little easier.I managed to get all the parts needed from flee bay and the whole lot cost me £30 including postage. Fitted and working in an hour!! There's no need to take the bumber off so was a lot easier than i thought. The loom for the switch was in place, just the connector tucked back into the foam.The drivers side of the motor loom was a little bit of a fiddle but with all the lights and air box out wasn't too bad, no need to jack the car up. Link to post Share on other sites
Recommended Posts