jezmoz 0 Posted September 17, 2007 Report Share Posted September 17, 2007 what is needed please....just engine and ecu?? Link to post Share on other sites
rigs 0 Posted September 18, 2007 Report Share Posted September 18, 2007 I think I'm right in saying that quite a lot of the loom is different also... its not easy thats for sure.Tom converted his and it was a bit of a bastard judging by the amount of swearing and abuse... Link to post Share on other sites
jezmoz 0 Posted September 18, 2007 Author Report Share Posted September 18, 2007 i'm not going to do a full transplant I just want the engine, Bottom end and head, I will fit obd1 mani etc to it . Link to post Share on other sites
adam_christie 0 Posted September 21, 2007 Report Share Posted September 21, 2007 So you're not converting to ODB2 then? So it should be pretty straight forward........? Don't quite understand what you're asking. ODB1 head and Bottom end are the same as ODB2. Link to post Share on other sites
vr6 g3 0 Posted September 21, 2007 Report Share Posted September 21, 2007 I think he's just wanting the later style chain/tensioner setup Link to post Share on other sites
jezmoz 0 Posted September 21, 2007 Author Report Share Posted September 21, 2007 nahh i want a donor engine as my rings are gone and it would be cheaper to get another engine, just wondered if i can use an obd2 engine and marry it with my existing obd1 manifold and ecu etc. Link to post Share on other sites
adam_christie 0 Posted September 22, 2007 Report Share Posted September 22, 2007 Will you be rebuilding the engine before you swap it with yours? I.e. new bearings, rings etc? Link to post Share on other sites
Recommended Posts