dubbin 0 Posted February 27, 2007 Report Share Posted February 27, 2007 wasnt really sure wher to put this post, but heres the problem anyways, when i installed my ddi gauges i took the needles off to paint them red, but since i put them on they keep slipping down to the bottom of the guage, are they not pushed in far enough or what, any ideas anyone, it only does it with the fuel gauge and the temp, the speedo and the rev counter are finecheers derek Link to post Share on other sites
cadguy77 0 Posted February 27, 2007 Report Share Posted February 27, 2007 did you re-postion the neddles once you put the back on ie. swing them clockwise 180° then back to zero? Link to post Share on other sites
dubbin 0 Posted February 27, 2007 Author Report Share Posted February 27, 2007 sounds like a plan mate, i will give that a try.cheers Link to post Share on other sites
cadguy77 0 Posted February 27, 2007 Report Share Posted February 27, 2007 once you start swinging them back anticlock towards zero you should feel resistance, if not turn clockwise more then back again towards zero until you do Link to post Share on other sites
dubbin 0 Posted March 5, 2007 Author Report Share Posted March 5, 2007 all sorted now, was swingin them the wrong way, quite fiddly job, but all sorted now, cheers! Link to post Share on other sites
Recommended Posts