michael5556 247 Posted January 25, 2011 Report Share Posted January 25, 2011 I have acquired a garrett t25 for a very small fee. But it has been sitting around on a shelf for a while. Minimal play in the shaft. But looking to get it reconditioned to be on the safe side. Anyone know if this is difficult to put in new bearings etc? Or shall I just send it off to a specialist? Link to post Share on other sites
michael5556 247 Posted January 27, 2011 Author Report Share Posted January 27, 2011 Bump Link to post Share on other sites
legvw 0 Posted January 27, 2011 Report Share Posted January 27, 2011 Its your choice whether you diy or use a specailist, but i've rebuilt my t60-1 turbo which was easy enough. Some of the bolts sheared off but i managed to get them out.I bought a kit of of ebay which included all bearings plus a 360 thrust washer, all seals, and new bolts. Link to post Share on other sites
Recommended Posts