IanH26 0 Posted November 16, 2010 Report Share Posted November 16, 2010 Hi,I have a MK3 VR6 that recently had an an OBD1 to OBD2 conversion.During the conversion I have been told that the servo and MC were removed.At a track day following the swap I noticed the pedal had to be pushed further before getting a bite from the brakes, The pedal seems to have come back into the car more than before.The brake light switch is activated if I barely touch the pedal.I have searched and found that there is a white plastic connector block on the back of the pedal where the push-rod connects the pedal to the servo.On checking my car this plastic clip moves and is loose.My question is... How do I fix the problem??Do I need to get a new clip for the back of the pedal and refit to cure the sloopy feel?Is there anything else I should check?Any advice, guidance, pics etc gratefully received,Ian Link to post Share on other sites
wag 0 Posted November 16, 2010 Report Share Posted November 16, 2010 id also check that the brakes have bleed out properly as this is normaly the reason for excessive freeplay in the brake pedal Link to post Share on other sites
Recommended Posts