nai 0 Posted July 23, 2010 Report Share Posted July 23, 2010 Hi allI have a vr6 and would like to know whats the best way to stick the side strips down as the clips that you push in dont hold very well.I was going to use silicon but not sure. can someone advise ?thanks Link to post Share on other sites
vr6stormt 0 Posted July 23, 2010 Report Share Posted July 23, 2010 tigar seal mate its good for all sorts all good body shops use it Link to post Share on other sites
Dragon Dave 1 Posted July 23, 2010 Report Share Posted July 23, 2010 tigar seal mate its good for all sorts all good body shops use itI can't read what your sayin....I just can't concentrate on the words......it must be your avatar distracting me as to the original question....if you push the clip into the door first, before you clip it to the side strip it works much better. You will feel it clip into the door properly and you will know it's not coming out. Then push the side strip onto the clip.There should be some green rubber gromets that the clips go into before they go into the door.....just checking it's not those that your missing.If the clips are broken, they are cheap as chips from VW Link to post Share on other sites
nai 0 Posted July 23, 2010 Author Report Share Posted July 23, 2010 i have the clips but it dont seem to fit? are clips for the door strip and the rear arch strip different? Link to post Share on other sites
Dragon Dave 1 Posted July 23, 2010 Report Share Posted July 23, 2010 Yes there are some different clips. I can remember there were different clips on the ends of each strip to the ones in the middle of the strip I can't remember the difference between the rear arch and door. Link to post Share on other sites
nai 0 Posted July 23, 2010 Author Report Share Posted July 23, 2010 ok i might just stick them down...thanks for the info guys Link to post Share on other sites
Recommended Posts