mlr55 0 Posted February 20, 2010 Report Share Posted February 20, 2010 Evening guys, Bought a vr6 highline a couple of weeks ago, completely standard apart from a milltek exhaust, the car has been on the drive while iv been working on it and its started everytime, drove it up and down the road etc but today when I came to start it after driving to the bodyshop it just wouldnt start......it trys to turn over, it has a spark and it has fuel going to it but its just not firing up. The car is a P-reg and has done 133k with a slight rattle on the chains, Had abit of mayo in the oil cap if that helps but i think thats down to the car not being run properly for awhile.Any help would be much appreciated thanksMartin Link to post Share on other sites
Mark_H 0 Posted February 20, 2010 Report Share Posted February 20, 2010 HI, have you tried putting VAGCOM on it ??? to see if there's any codes. It might have got choked up if it;s not been run until warm... Might be worth taking the plugs out and clean them Link to post Share on other sites
mlr55 0 Posted February 20, 2010 Author Report Share Posted February 20, 2010 Cheers Mark I will try that tomorrow if my mate digs his vagcom outalso give the plugs a clean I think. Link to post Share on other sites
tomsdubs 0 Posted February 23, 2010 Report Share Posted February 23, 2010 Mine did this the other day, it was frozen really well though. I just tapped the throttle as i fired it. Link to post Share on other sites
Recommended Posts