ric_vr6 0 Posted February 24, 2008 Report Share Posted February 24, 2008 My stainless 6-2-1 manifold came today so within in 4 hours id fit it. However on puting the car back together its now not running right! It judders and holds back under 2000rpm.Iv tried unplugging the air sensor, still the same.Iv taken it out for a long run after fitting, no joy there.I took the throttle body off and cleaned the shite out of it.Could it be the leads/plugs?Could it be the cat?The car was fine before i changed the manifolds over now its poorly. Link to post Share on other sites
vdubgirl 3 Posted February 25, 2008 Report Share Posted February 25, 2008 Moved to correct forum Link to post Share on other sites
VR6_Absy 0 Posted February 25, 2008 Report Share Posted February 25, 2008 Sounds like you haven't connected a sensor or you've got a dodgy connection, recheck the lambda sensor connection on top of rear engine mountVagCom as always might help you track it down Link to post Share on other sites
VR6_Absy 0 Posted February 25, 2008 Report Share Posted February 25, 2008 Sounds like you haven't connected a sensor or you've got a dodgy connection, recheck the lambda sensor connection on top of rear engine mountVagCom as always might help you track it down Link to post Share on other sites
Dave Lea 4 Posted February 25, 2008 Report Share Posted February 25, 2008 have u heat wraped it Link to post Share on other sites
ric_vr6 0 Posted February 26, 2008 Author Report Share Posted February 26, 2008 Yes heat wraped before i put it on! Link to post Share on other sites
Recommended Posts