ian1966 0 Posted February 17, 2008 Report Share Posted February 17, 2008 Hi ive got a problem. Ive changed my cluster dials for plasma 1s, everything works except my LCD displays anybody got any ideas? Link to post Share on other sites
xyber 1 Posted February 17, 2008 Report Share Posted February 17, 2008 make sure the multi plug has fully clicked back into place Link to post Share on other sites
ian1966 0 Posted February 17, 2008 Author Report Share Posted February 17, 2008 cheers ill check tha but If its not that what else might it be? Link to post Share on other sites
xyber 1 Posted February 17, 2008 Report Share Posted February 17, 2008 the solder on the board can crack and can need re soldering, but i would guess its just a bad connection, mine were abit sketchy aswel when i fitted them, turned out is was just a sticking needle Link to post Share on other sites
ian1966 0 Posted February 17, 2008 Author Report Share Posted February 17, 2008 If it needs soldering. How will i know , who do i get to check it out. Link to post Share on other sites
Phat VR6 3 Posted February 17, 2008 Report Share Posted February 17, 2008 muit meter to check conection Link to post Share on other sites
ian1966 0 Posted February 17, 2008 Author Report Share Posted February 17, 2008 Cheers ill try that & see how i go . Link to post Share on other sites
xyber 1 Posted February 17, 2008 Report Share Posted February 17, 2008 When i looked into it Lucas where gonna do it as they said they'd done a few in the past Link to post Share on other sites
Recommended Posts