ben_notts 0 Posted July 23, 2007 Report Share Posted July 23, 2007 ive got the climatronic setup on my P reg VR and when i start the car up it takes around 30 secs. for the lcd screed to stop flashing and to be able to control the fan as that starts to blow also - is this to do with it measuring the temps as its just been started up?also the A/c doesnt blow cold - ive checked to see if there is any gas in there but when i pushed the valve in there was no gas - could this be a case of it not being gassed up and is there a telltale sign if the compressor had packed in as someone mentioned that could also be a fault?cheersB. Link to post Share on other sites
craggsy 91 Posted July 23, 2007 Report Share Posted July 23, 2007 You have a fault, more thatn likely needs regassing. As mine does it evry so often. But mine needs regassing as i just use that stuff from halfords just to put some in so display doen't do that Link to post Share on other sites
ben_notts 0 Posted July 23, 2007 Author Report Share Posted July 23, 2007 do you think if i fill the tubes with compressed air from a can of air duster/ spray that id be able to get a small amount of pressure into the nipple just to see if it holds its charge like a tightness test as such?If i get it vagcommed will that highlight the fault as ive been quoted £50ish to get it tested - or is that a rip off, anyone know where i can get it done cheaper/ reccomend anyone to do it? Link to post Share on other sites
craggsy 91 Posted July 23, 2007 Report Share Posted July 23, 2007 Just get it regassed or even serviced Link to post Share on other sites
xyber 1 Posted July 23, 2007 Report Share Posted July 23, 2007 Id get it regassed and serviced. You need to run a/c for 30 mins or so every month just to keep it maintained and the seals in good condition, or they dry out and start to leak Link to post Share on other sites
ben_notts 0 Posted July 23, 2007 Author Report Share Posted July 23, 2007 nice 1 chaps. Link to post Share on other sites
Recommended Posts