markrob 0 Posted September 14, 2006 Report Share Posted September 14, 2006 just had a service done on my VR and they ahd to mill the pads down abit cos when they put the alloy back on it wouldnt move i think the alloys that i have on are ET34 how do i remedy this? also anyone got any ideas for a nice euro look alloy?cheers Mark Link to post Share on other sites
markrob 0 Posted September 14, 2006 Author Report Share Posted September 14, 2006 bump???? Link to post Share on other sites
crish72 0 Posted September 14, 2006 Report Share Posted September 14, 2006 All depends on the alloy and not so much the offset(although 35 is what a lot of people run). My last set also caught on the calipers so i ground a chamfer on the calipers.Another method is to just space your wheels out a few mm.Euro look alloys, have a search around on this site,plenty of photos about.Chris Link to post Share on other sites
Recommended Posts