Jump to content

aalborg

Members
 View Profile  See their activity

  • Content Count

    5

  • Joined

  • Last visited

Community Reputation

0 Neutral

See reputation activity

About aalborg

  • Rank
    Newbie

Profile Information

  • Location
    Norway

Community Map

View full sized map

  1. aalborg
    It was the engine speed/reference sensor (G28) causing this problem. Yesterday I bought the Bentley manual and found the needed information. I measured the resistance in the sensor while engine was cold, then drove some trips around the neighborhood until it stopped. And now the ohmmeter showed an open circuit. (infinite ohms). When the engine cooled down the sensor suddenly showed about 1100 ohm, and I was able to drive home knowing that my WR6 will be OK again. Reading the manual and faultfinding on the engine, I don't think any of the temp-sensors nor the hall sensor will give a directly s
  2. aalborg
    Hello, as I'm strugeling fault finding on my stalling VR6, it had been a great help to have a wiring diagram and/or a manual to look up in. Does anyone know where to buy*/find this? The VW dealer is not willing to hand out any such information. Best regards KIm
  3. aalborg
    Thank you. Some more questions: Is this one of the three sensors placed beside each other? Two of them was with four pins, placed on each side of a two pin one. (One black one with a yellow ring, on the left side, and one green one on the right side). When I went to my VW dealer yesterday, the guy in the spare part shop looked the part up on his computer, he said:"here it says that the sensor giving signals to the motronic and different others is black and yellow, but its now replaced with a blue one". So, I went home and replaced the black and yellow sensor. When I took it out, it had a diff
  4. aalborg
    Hello, I'm new on this forum. I have a VW Caravelle 98/99 with a VR6. Yesterday, as it was like a warm summer day here in Oslo, the motor stalled when it became warm. The watertemp indicator seemed stable at around 90 degree C. When the problem first occured, I was running at about 90 km/h. Suddenly the rpm indicator went to "0" and I lost the power. To me it seemed like the power for ignition and rpm meeter was cut off directly. All other equipmend seemed to have power. When I tried to start again the motor turned OK with the starter but there was no attemt to fire. I tried again, serveral ti
×
×
  • Create New...