bazz780 0 Posted May 26, 2006 Report Share Posted May 26, 2006 hey guys, had a new water pump and temperature sensor/switch fitted last week.now what happens is that the temperature switch sits at 70 degrees when the car is turned off and about 110 degrees when the car is on (never sees 0)what can i do to re-align the needles or is there something wrong with the switch? disconnecting the switch does not allow the needle to drop when car is off. Link to post Share on other sites
speed_freak 0 Posted May 26, 2006 Report Share Posted May 26, 2006 it sounds to me like someone has taken the needle off at some point and put it back on wrong Link to post Share on other sites
jb9999 0 Posted May 26, 2006 Report Share Posted May 26, 2006 Have you not just put new white guages in Baz? or new dials of somekind. Lol. Take the needle back off and zero it. :-d Link to post Share on other sites
bazz780 0 Posted May 26, 2006 Author Report Share Posted May 26, 2006 i did that already, but it keeps moving out of place, maybe iv damaged the grip? Link to post Share on other sites
jb9999 0 Posted May 27, 2006 Report Share Posted May 27, 2006 Sounds like it. I'd superglue it where it should go. Link to post Share on other sites
Recommended Posts