northernVR 0 Posted October 22, 2017 Report Share Posted October 22, 2017 Evening folks, Need some assistance please. I’m on the final stages of getting my AUE 2.8 24v into my Corrado. I done a trial fit today as I’m doing it without much research and found the drivers engine mount nowhere near lines up to where it should bolt in. Any advice, do I need another engine mount from elsewhere? Help much obliged. Link to post Share on other sites
Vw_owner 1 Posted October 22, 2017 Report Share Posted October 22, 2017 Hi bud , you need to use the original vr6 engine mount , mk4 mounts are totally different and in a different location,, your see on the back of the engine {in a sqaure} the four mounting points ,, it might pay for you to run a tap down the threads as they may be full of rust, just google image vr6 engine mountings if your unsure Link to post Share on other sites
Recommended Posts