dubvr691 7 Posted April 27, 2017 Report Share Posted April 27, 2017 Putting the clutch back together and got the slave cylinder off, is the pin that pushes against the inside ment to have presure on it, do I have to drain it or am I meant to have the clutch pedal pressed before fastening it back in? Anyone ?¿? Link to post Share on other sites
Jimjon 28 Posted April 28, 2017 Report Share Posted April 28, 2017 Yeah, should have pressure there, you have to push it in quite hard to compress it while trying to get the two bolts in place Link to post Share on other sites
dubvr691 7 Posted April 28, 2017 Author Report Share Posted April 28, 2017 Yeah thers a fair bit of pressure in it, but while fastening am I to have the clutch pedal pressed before fastening, because atm iv put it back together but the clutch keeps slipping drastically in drive and is simply not putting any Power down at all, nothing past 3000rm its just slipping on, I understand iv to bed the clutch & flywheel in over next several 100 miles, but would a fresh clutch be a reason for it to be slipping like this or have I got something wrong with re assembly Link to post Share on other sites
Timothy_Ellis 23 Posted May 2, 2017 Report Share Posted May 2, 2017 You have something terribly wrong. Link to post Share on other sites
dubvr691 7 Posted May 2, 2017 Author Report Share Posted May 2, 2017 You have something terribly wrong. Yeah tell me about it, we'll iv ordered a replacement master cylinder, hopefully it'll be what it takes to solve this issue Link to post Share on other sites
Timothy_Ellis 23 Posted May 2, 2017 Report Share Posted May 2, 2017 Had the same issue on mine. Years ago. I believe it was the master cyl. I replaced it all though. Link to post Share on other sites
dubvr691 7 Posted May 2, 2017 Author Report Share Posted May 2, 2017 By all you mean? Link to post Share on other sites
Timothy_Ellis 23 Posted May 2, 2017 Report Share Posted May 2, 2017 Master, slave, hard line, clutch disc, pressure plate, throw out bearing and pilot bearing. dubvr691 1 Link to post Share on other sites
Timothy_Ellis 23 Posted May 2, 2017 Report Share Posted May 2, 2017 All of it. dubvr691 1 Link to post Share on other sites
Recommended Posts