rich 40 Posted December 10, 2016 Report Share Posted December 10, 2016 I got to do the dreaded heater matrix as my cabin turns into a sauna when its plumed in!!!.anyone know the best way to do it??can it be done without taking the dash completly out??cheers. Link to post Share on other sites
palmer 17 Posted December 10, 2016 Report Share Posted December 10, 2016 I have a vague recollection of somebody saying they did it without removing the dash but i can imagine that being insanely awkward. Although removing the dash is a time consuming task if you do it slowly and pay attention to where things come from its not too bad of a job. I just ripped it all out did the matrix and threw it all back in, didn't take too long. rich 1 Link to post Share on other sites
VR6 Supercharged 104 Posted December 10, 2016 Report Share Posted December 10, 2016 (edited) Time too consult the Haynes manual me thinks.. As I know the dash had to come out of the van when that went a few yrs back now. As stated though, be careful an make sure you don't trap anything putting it back, as the guy that did the one on my van (Ye course I know what i'm doing) trapped wire and things, and afterwards certain stuff stopped working.. Edited December 10, 2016 by VR6 Supercharged Mispelling rich 1 Link to post Share on other sites
rich 40 Posted December 11, 2016 Author Report Share Posted December 11, 2016 cheers lads,yep I know its going to be a nightmare but was hoping someone had done one and would give me a few pointers...but needs doing as its fcukin freezing... VR6 Supercharged 1 Link to post Share on other sites
Tank_VR 25 Posted December 13, 2016 Report Share Posted December 13, 2016 Mine needs doing too... taking the dash out is the hardest part really, just need some patience and you'll be done in a couple hours rich 1 Link to post Share on other sites
Recommended Posts