Jump to content

Recommended Posts

Apologies if this is covered in another thread, i've been searching the net for a few hours now and i am still confused?!

I've put a vr6 into my mk1 caddy, using the complete mk3 loom and have spliced it into the mk1 dash loom. its an obd2 with air con (which i have removed).

I have a custom radiator made up, with 2 spal fans that i am trying to wire in. I have a 4 pin socket, and i am wondering what is the best way to wire the fans in? I would like to keep the low/med/high functionality if possible. Can i just connect the 3 speed wires to the fans via diodes? (like the chap did in this thread http://forums.vwvortex.com/showthread.php?5637123-Aftermarket-radiator-w-slim-fans-need-feedback-on-my-wiring-plan&p=77331329&viewfull=1). Should i look at removing anything else that was AC related, i understand the 3rd speed is there because of the AC? therefore its now redundant?

Thanks

 

 

 

Link to post
Share on other sites
×
×
  • Create New...