D11PS 146 Posted March 24, 2014 Report Share Posted March 24, 2014 Afternoon all, I've been looking at using water injection for quite some time and I can't make up my mind if it's worth it or not. Has anyone used this? What make/models were used? What were the results and would you recommend it? Thanks VR6Pete 1 Link to post Share on other sites
MaidenVR6 26 Posted March 24, 2014 Report Share Posted March 24, 2014 Its a smart upgrade and insurance for your FI engine.I have a Coolingmist stage 3 kit that are gonna be mounted this summer.Snow performance also have nice kits. VR6Pete 1 Link to post Share on other sites
D11PS 146 Posted March 25, 2014 Author Report Share Posted March 25, 2014 Thanks for reply, I think I may go down that route too.What ratio do you mix the methanol/water?Sent from my GT-I9505 using Tapatalk Link to post Share on other sites
MaidenVR6 26 Posted March 26, 2014 Report Share Posted March 26, 2014 50/50 is what AEM say are the optimal mix. More meth isnt gonna be any better.Search "water methanol" on the tube. Link to post Share on other sites
Gazbarber1982 3 Posted April 1, 2014 Report Share Posted April 1, 2014 I'm running 30/70. I've installed to aid cooling of internals in my charged VR.Sent from my iPhone using Tapatalk Link to post Share on other sites
D11PS 146 Posted April 1, 2014 Author Report Share Posted April 1, 2014 (edited) I'm looking to go down the AEM route for my charged VR. GaZ what differences have you found using water injection? Other than lower engine temps and the prevention of early detonation Sent from my iPhone using Tapatalk Edited April 1, 2014 by D11PS Link to post Share on other sites
michael5556 247 Posted April 1, 2014 Report Share Posted April 1, 2014 Have a look at devils own. Link to post Share on other sites
Recommended Posts