goodboy1451 0 Posted February 16, 2005 Report Share Posted February 16, 2005 Hi Gurus,I guess this might have been asked before. Is it worth the money to remap the VR6 if I just have the schrick VGi and BMC CDA installed ?? It will cost about 400 quids and would you really feel any improvement from the torque and horsepower perspective ?? Help me guys....to decide. &| Link to post Share on other sites
ingham 5 Posted February 16, 2005 Report Share Posted February 16, 2005 stanard map have flat spots built in,custom maps are lots better,will drive a lot better Link to post Share on other sites
VR6Pete 1,455 Posted February 16, 2005 Report Share Posted February 16, 2005 goodboy1451: if you have other mods in mind for the future, then get a dastek unichip. they cost around the 400 mark, but can be remapped easily for the cost of a RR session if you have any future mods in-mind. Pete Link to post Share on other sites
goodboy1451 0 Posted February 16, 2005 Author Report Share Posted February 16, 2005 Cheers folks!!! I have booked a slot with Stealth. Link to post Share on other sites
binliner 0 Posted February 16, 2005 Report Share Posted February 16, 2005 Getting one of those fitted on Friday Link to post Share on other sites
DundeeDub 0 Posted February 16, 2005 Report Share Posted February 16, 2005 i'm going to be getting mine done to within the month at the Dastek factory as its just down the road Link to post Share on other sites
binliner 0 Posted February 16, 2005 Report Share Posted February 16, 2005 Im going to Engine Advantages in Essex... they did a good job on mintys and I think Tandino took his there as well plus its only 10 mins away Link to post Share on other sites
malcolm 0 Posted February 16, 2005 Report Share Posted February 16, 2005 Andrew, where is Dastek factory and how much is it costing you, also assume they do remapping onsite Link to post Share on other sites
Recommended Posts