Jump to content

Recommended Posts

hello just swaped my vr engine for a lower milage one as i blew the conrod through the old block :S

the problem is my car just dont want to fire up i swaped the ecu new crank and cam shaft sensors and transponder unit for the key all for the new engine i put in.

it all come out of a running motor that had an eventful smash oops

i have checked all the wired fuses ect but no joy and i have found out that there is no fule going into the engine but all the fuses and relays are fine any ideas ???

pleasw help as i cant stand to see my car just sitting there doing nothing.....

Link to post
Share on other sites

How come you swapped the ecu etc? You could have left all of your ecu, transponder etc in the car, and just swapped all the engine ancillaries over. I did it at the weekend, put an obd1 set-up engine in an obd2 car just by swapping everything on the obd2 engine onto the obd1 engine. Fired up first time.

Link to post
Share on other sites

i still have the old ecu transponder and stuff but it just wont fire up and now the fule pump wont work if anyone on here who knows what there doing and fancys a challenge pop down and have a tinker with it pm me for my address

Link to post
Share on other sites
  • 5 months later...
×
×
  • Create New...