shawry 0 Posted February 19, 2011 Report Share Posted February 19, 2011 Any 1 on here got sumpguard fitted looking at making 1 for when I lower my vr I've seen a pic of 1 from an american company but its far too dear so going make 1 similar to what I've seen Link to post Share on other sites
VR6Pete 1,456 Posted February 19, 2011 Report Share Posted February 19, 2011 Ive got a copy of a masontech one. Not fitted it yet! Link to post Share on other sites
shawry 0 Posted February 20, 2011 Author Report Share Posted February 20, 2011 This is like the 1 I'm looking at making but out of some 3mm galv plate I've got lying round instead of alloy Link to post Share on other sites
Caddyslammed 16 Posted February 20, 2011 Report Share Posted February 20, 2011 I have got a masontech on my car, but i cant remove it!, good luck with this mate, they are overpriced. Link to post Share on other sites
shawry 0 Posted February 20, 2011 Author Report Share Posted February 20, 2011 I have got a masontech on my car' date=' but i cant remove it!, good luck with this mate, they are overpriced.[/quote']Could u tell me where the back 2 bolts go it says they use existing holes ??? Link to post Share on other sites
Caddyslammed 16 Posted February 20, 2011 Report Share Posted February 20, 2011 Hmm, can't see under my car, what i'll do is scan the fitting instructions and post a pic on here m8. Link to post Share on other sites
shawry 0 Posted February 20, 2011 Author Report Share Posted February 20, 2011 Nice 1 mate any chance u could email em 2 me if I pm you my address?? Link to post Share on other sites
Caddyslammed 16 Posted February 20, 2011 Report Share Posted February 20, 2011 no problem Link to post Share on other sites
Caddyslammed 16 Posted February 20, 2011 Report Share Posted February 20, 2011 Link to post Share on other sites
shawry 0 Posted February 20, 2011 Author Report Share Posted February 20, 2011 Nice 1 this really helps me out now to c how it goes Link to post Share on other sites
Ian_rogers 0 Posted February 20, 2011 Report Share Posted February 20, 2011 I want one :-( Link to post Share on other sites
Caddyslammed 16 Posted February 20, 2011 Report Share Posted February 20, 2011 Also sent you jpegs via email mate, it was fitted to my car when I bought it, and is essential! Link to post Share on other sites
davidvsb 0 Posted February 20, 2011 Report Share Posted February 20, 2011 I've got a masontech copy one on my mk2. Had to weld two captive nuts in the subframe at the back and drilled and fitted riv-nuts in the front cross member. Link to post Share on other sites
shawry 0 Posted February 20, 2011 Author Report Share Posted February 20, 2011 Right I've made a cardboard template using welding rods for strength so I got the right angles looking pretty good jus gotta transfer it into steel next weekend then just need weld some nuts to the crossmember and subframe and it's done Link to post Share on other sites
Recommended Posts