sleepyVR 0 Posted February 6, 2010 Report Share Posted February 6, 2010 My vr had been in for a service iv replaced the chains and tensioners also upgraded to kent 268 cams. How many miles will it take for the cams to be bedded in? After a full service plus a new clutch is tempting putting your foot down. Link to post Share on other sites
bungy 2 Posted February 6, 2010 Report Share Posted February 6, 2010 I think the key part for bedding in cams is to roll on and off the power and to not hold one set rpm. Do this and gradually increase power over time. Not sure on how many miles is required though. I'm sure someone else will have a figure for you. Link to post Share on other sites
sleepyVR 0 Posted February 6, 2010 Author Report Share Posted February 6, 2010 Cheers fella appreciate your help. I got a feeling its few hundred miles. Link to post Share on other sites
Recommended Posts