Jump to content

Recommended Posts

Hi my abs light is on for the second time it came on when i first bought the car i fitted new front abs sensors on the front and this took the light off. but now its on again could it be the rear ones thats faulty now? cars done 158k miles and not sure when they was last changed. My friend whos a trained merc tech reconns its the brake switch at fault? whats ppls opinions on this?

Link to post
Share on other sites

This happened on my last vr. I replaced the lot sensors pads and still the light persisted. It turned out that it is a common thing with them. As far as I am aware not all vr have pad sensors it was only an added extra I think. But I had to just deal with it.

Try all that you can cos if your like me you will find that one in-perfection hell to deal with. But I had to mate hope you get it sorted.

Dave

Link to post
Share on other sites

I'm in most night after 6pm and only work Mon - Fri.........Mine's a code reader not VAG com but still found my faulty ABS ECU and front sensor fault.

I'm just off the M69 in Sapcote, just outside Hinckley.

Let me know if you want to pop over.

Mark

Link to post
Share on other sites

I'm in most night after 6pm and only work Mon - Fri.........Mine's a code reader not VAG com but still found my faulty ABS ECU and front sensor fault.

I'm just off the M69 in Sapcote' date=' just outside Hinckley.

Let me know if you want to pop over.

Mark

[/quote']

send me ur address Mark and ur number and ill pop over and get it checked out

Link to post
Share on other sites

Yes it shows the right rear sensor fault when the ecu goes??? if you change the sensor and it doesnt go away it will be the pump/ecu. To check if its the sensor swap the looms clear codes then check again once it faults if it still says right then you know its obviously not the right cos its getting a feed from the left as you swapped them?

Link to post
Share on other sites

Yes it shows the right rear sensor fault when the ecu goes??? if you change the sensor and it doesnt go away it will be the pump/ecu. To check if its the sensor swap the looms clear codes then check again once it faults if it still says right then you know its obviously not the right cos its getting a feed from the left as you swapped them?

I'd say the same thing. I had random ABS faults, changed a bunch of sensors. Turned out to be dry solder joints in ABS ECU, which i had re-soldered. My mech told me about the swapping of the looms under back seat as well.

Link to post
Share on other sites
×
×
  • Create New...