Jump to content

Recommended Posts

Right then here we go.

U706-1199556124.jpg

As you can see the sump in the way of the bolt.

U706-1199556201.jpg

Solution undo the 13mm bolt first to remove the bracket that holds the 2 conectors so as not to damage them. Then there is a 17mm bolt through the mount into the chassis.

U706-1199556370.jpg

Like so not too bad to get to. Then jack the engine up(use a piece of wood so you dont damage sump) you then have acces to the whishbone bolt

U706-1199556595.jpg

Then undo rear wishbone bolt, antiroll bar linkage, bottom ball joint (3 bolts). I also took off the hub nut to allow better access and the track rod end, put it all back together in reverse order and hey presto.

Hope this helps

Thanx to everyone for the advice Tongy

Link to post
Share on other sites
×
×
  • Create New...