Jump to content

headliner starting to fall at front


Recommended Posts

http://www.woolies-trim.co.uk/p-1263-heat-resistant-adhesive.aspx

I have use this while trimming my boot and to re stick my head lining, all stayed glued 2 years later and doesn't seem to budge.

You can either spray it with a compressor and spray gun, or try and apply it very even with a brush, it quite hard to do with a brush, as it an adhesive not paint, so it all sticks together while trying to spread it out. Spray gun is much better.

Also put it on both surfaces. The back of the material and the surface your sticking the material too. Apply it then leave for 5-10 mins until it has gone tacky. Then apply the material to the surface, I used a small wall paper edge roller. So I could roller over the whole material making sure all of it was stuck down.

Edited by c00k
Link to post
Share on other sites
  • 1 month later...
×
×
  • Create New...